0

Versatile Magnetic Wall Solutions

×

Registration

Profile Information

Login Data

or login

First name is required!
Last name is required!
First name is not valid!
Last name is not valid!
This is not an email address!
Email address is required!
This email is already registered!
Password is required!
Enter a valid password!
Please enter 6 or more characters!
Please enter 16 or less characters!
Passwords are not same!
Terms and Conditions are required!
Privacy Policy are required!
Email or Password is wrong!

Step 1. Prepare your wall

Wipe down your wall area ensuring there is no grease, dust or loose paint.
If you are painting your wall before installation, allow at least one week for the paint to cure properly.

 

Step 2. Guide line

We recommend drawing a horizontal level line to aid the alignment of your tiles.
Especially for the first tile as this will be the datum standard for your whole wall.

 

Step 3. Prepare the tile

On the top edge, fold back the backing paper to expose roughly 50mm of the adhesive
This will allow you to temporarily fix the tile with the option to change its position until aligned correctly.

 

Step 4. Alignment

With the exposed adhesive at the top, align your tile to the level line.
Take your time, this is the most important stage of making sure your Working Wall stays true throughout.

 

Step 5. Initial adhesion

Once Aligned, press the previously exposed adhesive to the wall.
Now is a good time to check the tile using a level.

 

Step 6. Removing backing paper

From the bottom, keep the tile away from the wall and slowly peel back the release paper.

 

Step 7. Application

Keeping the tile lifted away. Gradually press the adhesive onto the wall.
It is best to work top to bottom and left to right, ensuring that no bubbles form.

 

Step 8. Adding tiles

Use the vertical edge and top corner of the already applied tile to align your next.
Pay close attention to how well aligned the two meeting edges are.

 

Step 9. Repeat

Carry on applying your tiles as before in the previous steps.
To make application more manageable, you can reduce the amount of release paper you peel back.

 

Step 10. Trim to fit

Tiles can be easily trimmed to fit using a sharp knife and suitable metal edge.
Please make sure you are cutting the tile on a flat surface.

 

Step 11. Applying graphics

Align top and side edge of graphic to edges of the tile then simply roll out.
To remove the graphic just roll up from one edge to the other.

 
My Cart

You have no items in your shopping cart.